NOTE:  any configuration of fewer than three lights does not meet driver’s minimum load requirement.  Kit must be ordered with our load resistor (RSTR-LOAD) – quantity 1 per power kit.

For use only with MP Series luminaires.

Included in this kit: 

   a:  One (1) 110v to 277v AC to 12 volt DC 60W Class II SELV IP67 transformer (UL listed) with dimming leads for 3-in-1 dimming capability.
   b:  One (1) weatherproof enclosure + lid for power supply (UL listed) 
   b:  One (2) weatherproof terminal enclosure + lid (UL listed) 
   c:  Four (8) quick-jump bus bars

The driver in this power kit offers two separate dimming leads for DALI-1, DALI-2, KNX, and 0-10V dimming.  PWM dimming does not employ the separate dimming leads.  Dimming protocol must be indicated at time of ordering power kit.  NOTE: Per UL requirements, our luminaires are only approved for operation on a Class-II (max. 5-amp, 60-watt) 12vDC constant voltage driver.  Driver must not accommodate more than thirty apertures.  Adding more than thirty apertures to your driver will invalidate your warranty. For configurations of greater than 30 apertures, additional complete power kits are required.  Dimming on the mains voltage side will result in damage to lights and will invalidate your warranty.

Contact us for assistance.

Before installing, consult a licensed electrician to ensure proper safety procedures, and compliance with local and national codes and ordinances. Always wear PPE.

Subject to availability, MINIMIS reserves the right to substitute for “as good or better” items.

Note: Items may arrive in separate boxes, on separate dates.